Salut
j'ai trouver le codage Vcds pour Golf 7 et les leds pour l'eclairage de la plaque sur un forum US.
EDIT
Disable bulb out warning for LED licence plate lamps.
Select STG 09 (wiring)
STG access permissions -> Function 16
Enter Unlock Code 31347
STG adjustment -> function 10
(1) Select Leuchte25KZL HA59-load type 25
Customize LED general - value at 43
(6) Leuchte25KZL HA59 dimming AB-25 Select
Adjust value to 127
EDIT
Avec les photos....
If you have a set of aftermarket license plate LEDs (without resistors), you will need to code the bulb-out error message via VCDS.
The ones I used are from deAutoKey: deautokey error-free license plate LEDs
Step 1: Enter Central electronics module (09-Cent Elect.)
Step 2: Click Security Access (Security Access-16)
Step 3: Enter Unlock Code 31347, then click "DO IT"
Step 4: Click Adaptation (Adaption - 10)
Step 5:
From the drop down, select channel “(1) Leuchte25KZL HA59-Lasttyp 25” (Because this is way down the list, it's actually faster to start searching from the bottom up), and change New Value to “43 – allgemeine LED”. Click DO IT!
Step 6: Now select channel “(6) Leuchte25KZL HA59 Dimmwert AB 25” and enter New Value of “127”. Click DO IT!
Now you need to reset the lighting settings in the car to "factory" so it calls on the new values entered.
STEP 1:
STEP 2:
STEP 3:
STEP 4:
STEP 5:
et 
unancien!!
Ceux-ci ne laissent aucune trace. Cela facilite vraiment la vie pour toutes opérations de démontage
